Tag: origami crane

OrigamiOrigami

How To Make An Origami Crane- Pt 2 Making the Crane

This is the second part of my origami crane blog post, part one introduced the Inside Reverse fold which is the tricky part of making an origami crane.  In this part I’m going to actually make the crane 🙂

Origami Crane
Take a square of paper and fold it in half horizontally, vertically, and diagonally both ways. Then unfold it and you should have creases in your paper as above.
Origami Crane
Refold the paper in half diagonally, then in half again.
Origami Crane
Open out the first layer slightly, and slide you finger inside.
This origami has become unintentionally naughty sounding, I apologise.
Origami Crane
Continue to open out this top layer.
Origami Crane
Continue…
Origami Crane
Press down and flatten it.
Origami Crane
Turn over and repeat on the other side.
Origami Crane
You should end up with this.
Origami Crane
Position the folded square so that the open end is pointing down, while the folded edges are all at the top. Fold the top left and right sides into the centre.
Origami Crane
Fold the top point down, then unfold again. Turn over and repeat on the other side.
Origami Crane
Unfold and this is what you should have.
Origami Crane
Open out the top layer, pull the point at the bottom of the square to meet the point at the top.
Origami Crane
As you do that you you should gently flatten the left and right sides along the creases created earlier- and you wondered why we were doing all that folding and unfolding!
Origami Crane
Position the diamond so that the open ends are at the bottom and the folded edges are all at the top. Then fold the left and right points into the middle.
Origami Crane
Now it’s time for that Inside Reverse fold in Part One, do an inside reverse fold on the ‘legs’ folding them upwards but inside the rest of the origami.
Origami Crane
Do the same for both ‘legs’
Origami Crane
Do the same thing again but this time fold the right point down to create the crane’s head.
Origami Crane
Look at the crane from above like this, and gently pull it’s wings.
Origami Crane
And you’re done!
Origami Crane
The finish product.
Origami Crane and Swan
My growing paper aviary.

OrigamiOrigami

How To Make An Origami Crane- Pt One Inside Reverse Fold

I decided to have a go working on an origami crane which I think is a fun one.  Also, apparently if you make 1000 cranes your wish will be granted, which is nice.

The important and tricky thing about making cranes is that it features several ‘inside reverse’ fold which is easy once you’ve mastered it (but then again what isn’t!)  So below is my garbled attempt at explaining the ‘inside reverse’.

Origami Inside Reverse 2
Fold the paper in half
Origami Inside Reverse
On the folded edge fold the corner of the paper
Origami Inside Reverse
Completely unfold the paper, your paper will be creased now. Then pinch the paper where the three creases meet.
Origami Inside Reverse
Keep pinching with you right hand, and use a finger on your left hand to push the left corner in, using the creases you just made as a guide. I couldn’t show both my hands and take the picture, sorry!
Origami Inside Reverse
Once you’ve started the process it should keep going on its own.
Origami Inside Reverse
Pretty much the finish product.
Origami Inside Reverse
When you’re done it will look like this, with the folded section neatly hidden away.

I was going to have the Origami Crane all in one post but it would have been far to long with all of the above as well, so tune in on Friday (27th Sept) for part two, with the actual crane making!

Save